After trying soapy water and soap we finally discovered an easy way to find leaks using wet plastic wrap. Once we found the leaks we used a vinyl repair kit Use a 5mm drill bit and carefully drill out the hole. Using a grommet (supplied in kit) gently place into the newly drilled hole. Using water based lubricant, lightly spray area with lubricant and insert a small joining barb. Then join the solar tube back onto the other end of the joining barb. If the broken barb cannot be removed from the tube Method 1: Submerge the Float. This method works best if you have a small, lightweight float and don’t mind getting wet. Place your fully-inflated float in the pool, either by the side of the pool or by the steps. Submerge one part of the float at a time while checking for bubbles. Once you locate the leak, take the float out of the water, and It is an indoor inground pool. I have a hole in the sidewall of my skimmer (see picture (if the upload worked)). I was told by a pool contractor that as a temp fix I could fill the small void behind the hole and use a 2 part epoxy to seal/fix the hole so that we could fill the pool and test equipment and lines. Flex Seal pool patch kit is currently sold out on Amazon.To purchase flex glue mini on Amazon click: Comes in a small tube or small bottle. Just pour a small qty of resin into a paper cup. Put the recommended number drops of the activator to start the chemical reaction. The more drops of activator you used, the faster the resin hardens (to a point). The resin in the can will last a long time, it has a good shelf life. August 2, 2008. I've found that "Gorilla" brand tape will stick very well to almost anything, compared to duct tape. I even used it to "weld" a neighbor's broken-off right rear-view mirror to his car's door frame. I expect the pool would be in direct sunshine most of the daylight hours? Put the patch on your pool. If you’re putting a patch on a filled Intex pool or underwater, then you must put a small amount of patching adhesive from your kit onto the backside of your patch, then fold it in half to spread the adhesive. Wait for at least 10 minutes for it to cure, then immerse it into the water while you keep the patch folded. dqdbUSm.

how to fix a hole in pool